Power-Up | Riedel Online Help Center

Connect the SmartPanel with the mains voltage and wait until it has booted.
If the SmartPanel is not connected to a matrix, you will see the following content on the key display:

Intercom Mode	Shows the current selected intercom mode. (`Artist-1024`, `Artist-32/64/128`)
Intercom	Status of the connection to the matrix. (`No conn. to Matrix`, `Checking ...`, `Connecting Audio ...`)
Management Port Media 1 Media 2	Media 1/2	Shows the Ethernet port that is assigned to the corresponding `Media x` interface.
	Status	Status of the connection to the `MGNT/Media x` interface. (`Not OK`, `OK`)
	Config	Displays the current IP configuration of the `MGNT/Media x` interface. (`DHCP` or the statically set IP address `x.x.x.x`)
	IP	Displays the current IP address of the `MGNT/Media x` interface. (`N/A`, `x.x.x.x`)

With an Expansion SmartPanel, you will see the following content on the key display if it is not connected to the main SmartPanel:

Intercom	Status of the connection to the main SmartPanel.
Expansion Link	Status of the expansion interface connection.
Firmware	Displays the firmware version of the expansion SmartPanel.
Address	Displays the expansion address of the expansion SmartPanel.

As soon as the SmartPanel is connected to the matrix, the programmed key assignment is displayed.

The name (key label) of the corresponding channel is displayed below/above each lever key.
The subtitle (16-char subtitle) of the corresponding channel is displayed in the second line.