SimplyLive
2.2 2.1 2.0
2.2 2.1 2.0 English

Changing RC10 IP Address

The RC-10 needs to be connected to the same network as the NUC in order to connect.

The RC-10's Ethernet port is 10BASE-T only (10 Mb/s). Many modern NICs and switches handle 10 Mb/s poorly. If the RC-10 won't connect directly to the NUC or switch, use a 10/100 RJ-45 USB adaptor.

You can only change the RC-10's IP Address, Subnet Mask and Gateway IP from the RC-10 itself. It has no web config page.

Default network values

Setting

Default value

IP Address

192.168.1.200

Subnet Mask

255.255.255.0

Gateway

192.168.1.1

Change network via RC-10 keys

Key Combinations

Action

Hold “CLR” and plug in the power cable

Reset the network to default values

Press and hold for 3s: “LIVE” + “PLAY” + “PRV CTL” + “PGM1” + “PGM2”

Set IP Address

Press and hold for 3s: “LIVE” + “PLAY” + “PRV CTL” + “PGM1” + “PGM2” + “PGM1+2”

Set Subnet Mask

Press and hold for 3s: “LIVE” + “PLAY” + “PRV CTL” + “PGM1” + “PGM2” + “PGM1+2” + “MARK”

Set Gateway

Modify values

Key Combinations

Action

1 - 0

Enter the matching number

SFT

Move to next value (dot)

ENT

Save the setting, show status and reboot the RC-10

Example: set the IP Address to 192.168.0.201

Hold LIVE + PLAY + PRV CTL + PGM1 + PGM2 for 3s > 1 9 2 <SFT> 1 6 8 <SFT> 0 <10> <SFT> 2 0 1 <ENT>

Tip: Each combo builds on the one before. Subnet adds PGM1+2, and Gateway adds PGM1+2 and MARK.