On this tab, the live state of the SmartPanel is shown in real time, the rear side can be displayed, and the SmartPanel can be remote controlled. All actions, volumes and signalization are displayed as they are on the SmartPanel itself.
|
|
Hot-Mic-LED The status LED indicates that the panel microphone is open. |
|
|
Signalization of status icons and control signals Icons and control signals (e.g. Mute, Monitor, Outgoing Call, Beep...) are shown in the respective key display as long as they are active. Depending on the operating mode of the SmartPanel, the signalization takes place by icons (Talk-Mute) or by red/green bars/LEDs (Talk-Listen). |
|
|
Lever key with LED ring In addition to the indication of the LED rings, lever positions as well as turning and pressing the rotary control are displayed. |
|
|
Signalization of incoming calls Incoming calls are indicated by a blinking key display for 5 seconds after a call is being established.
|
|
|
Info-Display The info display also shows the currently active key bank with active status icons. |
|
|
Buttons The Show Rear button will illustrate the rear side of the SmartPanel.
|
|
|
Sidetone and volume The rotary encoders indicate turning and pressing. A flashing rotary encoder means that, for example, the microphone or speaker is switched off. |
-
The kind of signalization depends on the operating mode of the SmartPanel. In this example, Talk/Mute mode is shown, therefore icons are displayed as signalization.
(->Operation Mode) -
The View selection at the bottom right of the web interface can be used to adjust the size of the SmartPanel to the aspect ratio of the web browser window.