Web Interface | Riedel Online Help Center

The SmartPanel features a web interface for configuring and remotely controlling the SmartPanel. Enter the IP address of the Web Interface of the SmartPanel in the web browser of a PC on the same network.

To determine the IP address of the web interface, the interface of the SmartPanel (MEDIA 1/2, MGNT) via which the web interface can be reached must first be determined in Settings Menu > Appplications > WebUI. After that, the IP address of this interface can be retrieved in Settings Menu > Network.
A screen resolution of at least 1280×760 pixels is required to display the web interface.

General Behavior and Settings in the Web Interface

Most settings, such as changing switches or selecting checkboxes, take effect immediately in the system.
Some settings, such as changing IP addresses or stream settings, must be confirmed with the Apply button to apply the changes to the system.
The Cancel button discards all changes and the previous settings are retained.
If the web interface is opened, the Live View tab is displayed by default and – depending on the device settings – no other tabs can be opened or settings made.
To configure the device, you must first log in to the device (see Log-in in the table below).

The icons at the top of the web interface are independent of the selected tab.

	Home	Click to open the default Live View tab.
	Log-in	Click to log in to the SmartPanel. An active login is indicated by the blue icon. If you are logged into the SmartPanel, you can select additional tabs and make settings. Furthermore, the SmartPanel Remote Control is available. Click on the icon again to log out of the SmartPanel.
	Device Status / Log	Click to call up device messages. Errors will be indicated in red and warnings in yellow.
	License Manager	Click to display the licenses installed on the SmartPanel. The serial number of the SmartPanel is also displayed. Furthermore, additional licenses can be installed using the Add New button.
	Locating	Click to localize the SmartPanel. Active localization is indicated by the yellow localization symbol. The LED rings on all SmartPanel lever keys will blink yellow. Localization is active until you click on the icon again.

Web Interface Password Protection

The web interface of 1200 SmartPanels, which are connected to Artist-1024, can now be protected by a password to improve the security from unwanted remote access.

With a protected SmartPanel, only the Live View tab is visible. Other tabs cannot be selected and the SmartPanel Remote Control is disabled.

This function can be activated in the Director software in the corresponding SmartPanel properties. Information on this can be found in the Director user manual. No settings can or need to be made on the SmartPanel itself.

You can recognize a locked web interface by the presence of the gray login icon .