Sony RCP-3500
Production
Recommended for normal production use.
Caution
Compatibility Note: This information is a general guide and may be incomplete, may not match a specific project implementation, and is subject to change as supported products and versions evolve. Confirm the exact implementation and requirements for each project with Riedel and the relevant equipment vendor, then validate the required functions end to end in the target environment before deployment.
Minimum hi Version: v2.6.2
Overview
The Sony® RCP-3500 integration monitors and controls supported Parameters through Ember+. The template creates no signal Ports or Crosspoints.
Network Requirements
-
Allow outbound TCP from hi to the Ember+ Port that Sony confirms for the RCP-3500. The hi default is
9000.
Standards Conformance
|
Standard |
Conformance |
Notes |
|---|---|---|
|
Ember+ (Lawo) |
Glow DTD parameter tree per Ember+ spec |
Open community specification used as a de facto standard; widely adopted. |
Operator Workflow
-
The template creates no signal Ports or Crosspoints. It exposes Ember+ Parameters only.
-
Exposed Ember+ Parameters appear under the RCP Node in Inventory.
Connection Methods
Connection: Ember+
|
Property |
Value |
|---|---|
|
Protocol |
Ember+ |
|
Transport |
TCP |
|
Default Port |
9000 |
|
Authentication |
None |
|
Encryption in Transit |
None; the connection is plaintext TCP. |
|
Connection Model |
Persistent client connection from hi |
|
Required License |
hiBase |
|
Traffic Flow |
Bidirectional over a connection initiated by hi |
Required Configuration
The template has no Count or Start numbering with setting. Add one Node for each RCP-3500.
Device-Side Setup
Follow Sony RCP-3500 Integration Configuration for the device-side and hi-side configuration steps.
Supported Features
|
Feature |
Access |
Exposed Operation and Scope |
|---|---|---|
|
Ember+ Parameters |
Per-parameter access |
Read exposed Parameters and write only those marked writable by the Ember+ tree. |
Device Coverage
Confirm the RCP-3500 software version with Sony, and validate the required Parameters before production use.
Known Limitations
-
Available Parameters depend on the installed RCP software and configuration.
-
If Parameters do not appear, confirm that the RCP Ember+ service is enabled and reachable on the configured TCP Port.
-
hi sends an Ember+ keep-alive request every 5 seconds, and it disconnects when the provider does not answer within 10 seconds. hi requires the provider to answer keep-alive requests.
What's Not Supported
-
Sony CNA-2 REST or webhook operation through this template.
-
Firmware updates, calibration, or device-configuration backup.
-
Ember+ Functions, including Qualified Functions, and function invocation. The Ember+ specification defines them from Glow 2.20, and hi never sends an Invoke command.
-
Ember+ Templates, including Qualified Templates, and template references. The specification defines them from Glow 2.40. hi requests all fields of each element, and it does not resolve template references.
Trademarks
Note
Sony is a trademark of Sony Group Corporation.
All product names, logos, and brands are property of their respective owners. Copyright in third-party software and materials remains with the respective owners. Use of these names does not imply endorsement.
RIEDEL Communications is not affiliated with, endorsed by, or officially partnered with Sony unless explicitly stated.